Thanks for the pictures! You don't need reverse lights based on them so the part numbers you'd want are driver's side (assuming you need the license plate bracket), use part # 30-92-003 and part # 30-92-001 for the passenger side. view full answer...
The Stromberg Carlson Electric Trailer Jack part # JET-3755 is an excellent option for a 2008 Dutchmen Tab Travel Trailer. It will be a direct bolt-on replacement with plenty of capacity to lift and lower the trailer. I really like the Stromberg Carlson trailer jack because it has a built-in bubble level in the head which helps with leveling the trailer and the drop-leg feature again just makes things much faster. view full answer...
I do have an option for you but the Ventline Northern Breeze Roof Vents have been discontinued so replacement parts are hard to come by. We do not have the handle extension sleeve that goes between the knob and operator. The best option we can offer is to replace the entire vent for which I recommend the Ventline Ventadome Trailer Roof Vent part # V2092SP-28. view full answer...
From the edge of mounting flange that would sit on the roof to the inner plate that you would see inside the trailer is approximately 1-1/2". With it sitting down a 1/4" lower than the ceiling the mounting flange for the trim piece would never be able to sit flush against the interior ceiling so you would need to install some sort of spacer. This is super common when we install roof vents in enclosed trailers so we typically just build a small frame around the opening with some plywood... view full answer...
The LP tank does make it a little more difficult, but not impossible. I will say that the Ultra-Fab Folding Carrier # UF15-954730 will fit a 4" x 4" tube, so if the part of the A-Frame you want this to attach to matches this size, I do recommend it. The 60 pound capacity and ability to carry 5, 6, and 8 lug wheels, it is very versatile.
That being said, if the frame is 3" x 4" or 3" x 5", I suggest going with the Dutton-Lainson Offset Trailer Spare Tire Carrier # DL22120. The bottom of... view full answer...
Most of the old Atwood propane or carbon monoxide detectors have been discontinued and sold out so options are pretty limited. Since I don't know the model of your detector or size of your cutout hole I can't say for certain that the RV Propane Gas Detector # RS64FR will cover the existing hole, but I can say that it comes with two trim pieces with the following dimensions to help cover the old cutout:
The long plate measures 7-1/4" wide, 3-3/8" tall and hole to hole measurements of 6"... view full answer...
We do have an option for you to carry your bike rack while towing your trailer, though the part number you mentioned is not designed or rated for use with trailer towing, just flat towing (trailer towing has higher tongue weights than flat towing). So what you can use instead is a dual ball mount/hitch adapter:
- Curt Multipurpose Ball Mount with 2" Receiver # D210
The # D210 has capacities of 7,500 lbs towing/750 lbs tongue weight so it's more than enough for towing your trailer and... view full answer...
Go To Results